Catalog

T3 Turbo Items

Boost Control Solenoid XR (used)

Good used Turbo Boost Control Solenoid for all year XRs(BCS). Mounts to the inner passenger side fender near the coolant bottle. Do not have this item in new.

Price: $29.00

Center Housing Section T3 XR (used)
Good used T3 turbo water an oil cooler center section. Overall conditions vary. Some may use oversized shaft bearings (.010)

Price: $43.25

Clip Wastegate Actuator XR (new)
New correct replacement waste-gate actuator "e" secure clip. Fits all year XRs.

Price: $.79

Compressor Exhaust .48 Trim Housing T3 XR (new)-NLA
New replacement .48 trim exhaust housing for the T3 turbo. Many time after years of heat an cooling cycles the internal air flow chamber cracks internally an at the wastegate door orfice, these are new aftermarket replacement exhaust turbine housing. No Longer Available

Compressor Intake Housing .60 Trim Turbo (used)
Cold side Stock A.R. .60 Trim compressor housing in good used condition.

Price: $32.00

Intercooler Top Mount XR (used) - one left
Inexpensive way to add a intercooler to your 2.3 motor. This top mount intercooler is the most wallet friendly option to give cooling option to your turbo air charge. simple mounting without the need to get elaborate piping set ups. One left

Price: $85.00

Oil feed 90 degree fitting (new)
This fitting attaches to the top side of the center T3 turbo for oil feed line. Brass 90 degree fitting with tapered NPT threads to seal when installed. Brand new item.

Price: $5.05

Oil Feed Line Stainless Steel XR (new)
Remanufactured new stainless steel oil feed line for all year XRs in stock configuration. Comes pre-bent into OEM bends with threaded fittings on each end for attaching. Suggested that when servicing turbo system to replace oil feed hard line due to possible coking. This is a new item.

Price: $55.00

Oil Return 45 degree Fitting XR (used)
Good used 45 degree brass oil return line fitting. This mates the oil return line to the engine block. For those seeking new can supply, send inquiry if new is a must.

Price: $28.00

Oil Return Line XR (used)- one left
Good used stainless steel T3 turbo accordion oil return line for the 2.3 XR motor. one left, coms with new installation gasket.

Price: $65.00

Oil Sender Attaching Block XR (restored)
Here is a nicely restored XR oil sending / feed line attaching block. Crisp and clean with good treads and flush fitting flange. Fits all year XRs. Price is each.

Price: $12.99

Stainless Steel turbo to exhaust manifold gasket (New)
T3 XR4Ti turbo replacement mating gasket. this goes in between the turbo charger 4 bolt flange an the exhaust manifold 4 stud flange to seal mating areas. This is a new item.

Price: $8.50

T3 Turbo Rebuild XR (service)
We can rebuild your stock XR T3 Garrett turbo. If your shaft has play, wobble, or consumes oil its time to replace or rebuild. Prices start at $375 an include new bearings, new seals, new hardware, new carbon seal, an balancing compressor wheels. Does not include if any hardparts need to be replaced i.e. hot side compressor housing or turbine shaft. Serviceable core is needed.

Price: $375.00

Throttle Body Inlet Elbow Hose XR (used) one left
2.3 Flexible rubber Turbo inlet hose with a black factory outer appearance. Only have used available. Conditions vary by stock on hand. One left

Price: $32.00

Turbo Gasket Kit T3 (new)
New T3 turbo gasket kit! Includes stainless steel exhaust flange gasket an all other gaskets as seen in picture.

Price: $13.90

Turbo Locking Nut Set T3 (4) (new)
Set of 4 new T3 turbo self locking nut set. These new nuts lock into place as they are tightened down, removing the concern of vibration to back the nuts off.

Price: $9.99

Turbo Rebuild Kit Master T3 XR (new)
Master rebuild kit for all year XRs with the T3 Garrett turbo. Comes with new seals, gaskets, brass bearings, carbon seal, retaining clips, spring, piston ring, bolts and load brackets.

Price: $108.95

Wategate Actuator T3 (used)-one left
Good used stock Garrett T3 turbo waste gate actuator. OEM Style, bolt on with no modification or adjustments needed. Factory Garrett Wastegate actuator. Comes with new WGA rod retaining clip

Price: $59.00

For accurate shipping tabulation on multiple item shipping email Blugg@msn.com, otherwise shipping will tabulated per item instead of one whole transaction.